Radius mark in cad 20181/7/2023 ![]() This says the angle or bearing value is to follow …īearing Enter the bearing values in the proper format for Surveyor’s Units shown in the example, above. For the next point, enter the following value: Breaking it down After specifying the start point, says the following values are to go from where you’re at.ĭistance Enter the distance for that section of the property line (or road or culvert center line, etc.) Launch the Line command, then specify the first point.ģ. Begin a new drawing, then turn on Dynamic Input ( DYN button) on the Status bar.Ģ. The following exercise incorporates the DYN feature, just so you can understand how the dynamic entry feature works.ġ. ![]() MEMO: Although setting the drawing units to Surveyor’s is not required to draw with distance and bearing values, you will find the options in the Format menu > Units. Surveyor’s Units are entered using the following format: The key to the exercise is knowing what AutoCAD requires when you type in the distance and bearing values. I was training some folks at Cummins Engine Plant in Indiana, and one of the guys brought in a surveyor’s plan for his property asking how to enter the distance and bearing values from the site plan into AutoCAD.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |